Add and Remove Mesh Creases

Meshcrease

Sharpens the edges of selected mesh subobjects.

1. Type     MESHCREASE at the command prompt

                 Command: meshcrease

                  Select mesh objects to crease: select objects

                  Specify crease value [Always]<Always>: ENTER

            Before crease                                   Selected objects                           After crease

TIPS:

Crease Value:

Sets highest smoothing level at which the crease is retained. If the smoothing level exceeds this value, the crease is also smoothed. Enter a value of '0' to remove an existing crease.

Always:

Specifies that the crease is always retained, even if the object or subobject is smoothed or refined. A crease value of -1 is the same as always.

Meshuncrease

Removes the crease from selected mesh faces, edges, or vertices.

1. Type     MESHUNCREASE at the command prompt

                 Command: meshuncrease

                 Select crease to remove: select objects

                 Select crease to remove: ENTER

          Before uncrease                              Selected objects                          After uncrease